Jump to content

Flickering?


Recommended Posts

Hi.  It can help a lot if you can provide more information about the camera settings used to shoot the clip, but if you look carefully around the frame, including at the car and also the grass at bottom edge of frame, you'll notice they are also "flickering", although you mainly notice it in the leaves at top as that is where it is quite intense.

Looks like the camera is in autofocus mode... but I don't think that's a cause.

I'm thinking it's something to do with your exposure settings as it "almost" looks like a very fast exposure adjustment trying to compensate for the peak highlight of the sky just above your head ... what shutter speed, frame rate and ISO were you set at?  Were you using manual controls or some auto functions for exposure?

Link to post
Share on other sites

Hi. Thank you for your reply. I didn't read these out but in a previous recording in which the exact same problem occurred, I read off the settings of:

23.98 fps

1920 x 1080

PP 8

Shutter 1/800

F 4.0

Im fairly certain the ISO is 100. If it's higher it's not by much.

 

At the time I was attempting to to see if I could get the clouds and the subject. I wasn't concerned with the WB (obviously) but it was on Auto WB at the time.

 

It was recorded on autofocus because I've been testing that out to see how well it works with the face detection. When I recorded on manual focus, the flickering did not occur so it's possible that could be the cause. Other videographers i've followed have sworn by the face detection AF but if that's a side affect of AF, I wouldn't want to risk it. 

Link to post
Share on other sites

I'm tipping your shutter speed is the main culprit here.

1/800th is a very closed down shutter.... normally for video at 24fps (23.98 or 23.976 to be precise) you'd be looking at a shutter of around 1/60th of a second or 1/50th of a second, closer to a 180deg shutter.

Because you want a wide-open f-stop (4.0) at 100 ISO, normal practice would be to use a ND filter to reduce exposure, rather than reducing shutter speed so much.
You are compensating for about 4 stops of overexposure by reducing shutter speed where that should remain more consistent and the light is adjusted by other means, try it again at say 1/50th sec shutter with ISO at 50 and a 0.9ND (that would be around 4 stops to compensate for the shutter speed change)...  or if you have a polariser or variable ND try using that instead to cut some of the light... but keep your shutter speed around 1/50th.

:)

Link to post
Share on other sites

what camera and lens are you using?

Reason I ask is I did a quick handheld test outside on an A7r2 with Canon 17-40mm and didn't notice any flicker under similar lighting to your shot using similar settings, as well as what I suggested with variable ND, although I didn't check if face-detection was on, and I don't have a PP8 on the A7R2 (not that I think the picture profile has any affect here).
I'll test it again on a tripod with face-detection active...  I'm thinking maybe its a combination of the focusing with the shutter speed...

Link to post
Share on other sites

Ok so I've tried this at 1/60th SS and 1/800th with the AF and in every clip it shows the same fluttering image.

I've also tried it in every different AF video combination from multi zone to wide to center to flexi zone.

At this point I'm starting to wonder if this is a defect.  :huh:

 

It definitely appears to be an AF issue because there is no flickering in MF.

Link to post
Share on other sites

Ok so I've tried this at 1/60th SS and 1/800th with the AF and in every clip it shows the same fluttering image.

I've also tried it in every different AF video combination from multi zone to wide to center to flexi zone.

At this point I'm starting to wonder if this is a defect.  :huh:

 

It definitely appears to be an AF issue because there is no flickering in MF.

Do you have another lens you can test it with?

Link to post
Share on other sites

  • 3 years later...

Hi, did you solve the flickering issue? 

I bought a Sony Alpha 6400 and spend the full day yesterday filming. Almost all the footage is unusable due to the flickering. Annoying. Manual focus is not really an option since I am filming myself and very time consuming to set the focus.

It also happened with my Alpha 6300 but a lot less. 

Thanks.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Posts

    • I'd opt for a small zoom, but I must admit that there seems to be a dearth of lenses in the e-mount in the 24-50mm range -- for some reason.  I have a small 24-70mm, but that's an a-mount Tamron.  Maybe you can find something by looking at lenses slightly longer.  I have a heavy, but small 24-100mm a-mount, and Tokina made a 24-200mm a-mount.  Maybe there are similar lenses in the e-mount.  Kill three birds with one stone.
    • I recently got an a7cii and to pair with the compact body, I thought of getting 2 of the trio compact lenses, 24mm F2.8 and 40mm F4.0. (I already have a 70-200mm) However I stumbled upon the newly released 24-50mm F2.8 G. I'm not sure which to get - I like the small factor of the prime lenses ON the body because it's discreet and helps me blend in as an average tourist / doesn't make it obvious when doing street. But if I add the dimensions of the 2 primes together, it takes up more space in the bag than the zoom lens. BUT THEN, the weight of the 2 prime lenses is 110g lesser than the zoom lens. The zoom lens has the added benefit of being more versatile.   So now I'm stumped. Each has their pros and cons and I can't decide which to get. I'd like to hear the views of you guys who are more experts at this.   Edit: I'm a bit concerned about weight because the last time I went overseas my shoulders were aching from carrying too much. Which is why I was looking for small compact primes in the first place.
    • Hi, I have got a6300 which shutter stopped working. I managed to change shutter but unfortunatelly broke shutter motor tape but I fixed that. After repair the shutter is working but not in a proper way, watch with sound. I bought the second shutter and tried to test it before dissaembling again and it doesn't react to magnet but it works fine when I apply 3V. Are there different type of shutter for a6000 - a6400? Back to the question what is wrong with my shutter after first repair? I don't want to put next shutter unfoundedly. Do your sony cameras perform such a self-check after start up?  IMG_5579 (1).webm
  • Topics

×
×
  • Create New...