Jump to content

Recommended Posts

I am looking for a short HDMI cable to go from the camera to my monitor.  Ideally about a foot, with the large HDMI end bending 90 degrees like your hand bends, across the width. I don't really want a bend on the camera end. 

 

I've been looking on google, ebay, and amazon with no solution.  Too long, or wrong bend or the small end bending which would just be in the way.

 

Any ideas where I can find this?

Link to post
Share on other sites

I am looking for a short HDMI cable to go from the camera to my monitor.  Ideally about a foot, with the large HDMI end bending 90 degrees like your hand bends, across the width. I don't really want a bend on the camera end. 

 

I've been looking on google, ebay, and amazon with no solution.  Too long, or wrong bend or the small end bending which would just be in the way.

 

Any ideas where I can find this?

 

 

http://www.monoprice.com

Link to post
Share on other sites

Use an angle adapter. Couldn't find a short cable with angle connector built in. Verify the direction you need cable to exit before ordering. Four bucks. Amazon... 

Monoprice HDMI Port Saver Male to Female - 90 Degree (103733)

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Posts

    • Thanks for the information. Since my original post, I did some "experiments" at different iso settings. Best results were obtained at iso 320, and then increasing the exposure by four stops in Lightroom. The biggest difference compared to using a higher iso was that there was detail in dark foreground areas, while at high iso the dark areas were blocked. This is consistent with articles I've read about ISO invariance.
    • I do a bit of astro photography and do a lot of research etc. on best settings to use. I have never heard of anyone using ISO bracketing! Typically, higher ISO settings such as 1600, 3200 or 6400 are used and multiple light and dark frames are stacked to reduce noise. If you are worried about noise in dark foreground areas then just use a seperate exposure for them then blend the exposures in post processing. By the way, I also have an A7R5.
    • I would try resetting the camera. I can’t really think of anything else you can do other than try a different card.
  • Topics

×
×
  • Create New...