Jump to content

Replacing Lens Bayonet Mounting Ring


Recommended Posts

Has anyone in this group replaced the bayonet mounting ring on an FE lens?  My A7rII with 70-200 attached sustained a fall.  Fortunately everything works perfectly, but since then the lens mounts with more radial play than my other lenses.  It kind of annoys me.  I thought it might be a consequence of damage from the fall and replacement rings are available on Ebay for around $30.  However removing the current ring is a challenge, the four tiny Phillips head screws are so tight that I don't want to force the issue unless that is the norm.

Link to post
Share on other sites

They're not exactly philips. They are IIRC 

minicross [or something like that] and you 

need the correct tool as well as a solvent 

for the sealant that locks the threads. As 

there is no standard as to choice of which 

sealant has been applied, I'd try Goof Off 

cuz it works on almost everything and cuz 

acetone evaporates so fast it hardly has a 

chance to do its job.   

   

Full disclosure: I've never dismantled a lens

newer than an AI Nikkor, and would not buy 

any newer lens that cost so much that it's

not simply disposable, like a Dixie Cup .... 

UNLESS it's such a costly [and wonderful] 

lens that paying a profession to repair it is 

quite clearly worth it. IOW it's the middle

ground, value-wise, that tempts self repair.   

   

What is Primo, Middle Value, or Dixie Cup is 

relative to the user's finances, so I will not try 

to assign actual dollar values. I infer by your 

quandry that the lens in question is, for you, 

a mid-value lens. Flip a coin ? 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Posts

    • I'd use Focus Area: (Expand) Flexible Spot: S instead of Center. Smaller focus area and more control over where to focus. https://helpguide.sony.net/ilc/1710/v1/en/contents/TP0001653124.html
    • I am not sure what effect you are trying to achieve regarding the bluish cast of the water.  Do you want to neutralize it or enhance it?  It would be best if you Google polarizer filter for camera and look at the images and videos and see if you can find the desired effect that seem to mirror your situation.  If you can't find the effect you are looking for, it may not be possible to do so with the Polarizer.  I use the polarizer to minimize the shimmering reflections in the water that would look distracting in the image. Neutral density filters are used to reduce the amount of light coming into the camera.  If you want to shoot a small waterfall and you want to create an angel veil effect by reducing the shutter speed to seconds but the light conditions won't allow you to do so, you can use neutral density filters to shoot at very slow shutter speeds. Neutral density and polarizing filters can get very expensive.  If your lenses share a common filter size, that would be great.  If not, get the filters for the largest filter diameter lens and get a set of stepping rings to use with your smaller filter diameter lenses.
    • Advice needed on best use/settings - on full zoom using 200-600mm to capture a single, static bird at distance, the center focus area seems too large and will frequently focus on a point around or behind the bird such as branches or reeds etc. leaving the bird unclear. Is there a way to reduce the size of the center focus or should I be using a different setting? Advice appreciated - I'm still very much learning.
  • Topics

×
×
  • Create New...